CI Quickview: Documentation regarding attribute metadata requirements

According to the documentation: 

"Note: In CI Quickview Utilization Attribute display depends on metadata to Attribute association, so make sure your metadata is right."

But there is basically nothing else to describe what metadata you need to properly populate the CI Quickview page.

 

-------

The "Diskspace" section.  After a bunch of trial and error, I can get it filled out by using two attributes per drive.

Attribute: Total size in bytes

Metadata: Type=STORAGE; Detail = TOTAL; Label = "C:\"

Attribute: Used space in bytes.

Metadata:  Type=STORAGE; Detail = USED; Label = "C:\"

 

For the above example I used "C:\" because it was relatable.  In my purposes, it was for disk attributes collected on the IBM iSeries which are called ASPs.  I needed to reconstruct the metadata for those attributes.

-------

The "Network" section seemed to require the metadata of Index as well in order to show multiple interfaces.

Attribute: Ethernet1/1 AdminStatus

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = ADMIN_STATUS ; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 InErrors

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = INCOMING_ERROR ; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 OperStatus

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = OP_STATUS; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 OutErrors

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = OUTGOING_ERROR ; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 Total Traffic

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = TOTALTRAFFIC ; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 inbound traffic

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = INCOMING ; Index = Ethernet1/1 ; Label = Ethernet1/1

Attribute: Ethernet1/1 outbound traffic

Metadata:  Asset Name = Ethernet1/1 ; Type = Interface; Detail = OUTGOING ; Index = Ethernet1/1 ; Label = Ethernet1/1

-------

Essentially, I think it would be helpful to know the possible sections and valid attribute metadata combinations to fill in those sections.

Would someone know where the documentation is for this?